Curtis Cafe Primo Cappuccino - Connecting the Water Supply; Connecting the Power Cable (120 V); Powering Up the Unit

INSTALLATION INSTRUCTIONS II23
Style may vary
Installation
Leveling
1 Position the dispenser on the counter top. Level it left
to right and front to back by turning the bottom of the
legs.
Connect the Water Supply
2 Flush the water supply line prior to installation to
QVSHFBJSBOEEFCSJTGSPNUIFXBUFSmMUFSBOEUVCJOH
3 $POOFDUUIFXBUFSTVQQMZMJOFUPUIFnBSFmUUJOHPOUIF
back of the unit. Leave the water supply valve closed
until power is connected.
WARNING: Use the leveling legs to level the
dispenser only. Do not use them to adjust
dispenser height. Do not extend them higher
than necessary.
$"'&1$*/45"--"5*0/*/4536$5*0/4ø 120517NC
Back of unit
Back of
unit
Connect the Power Cable - 120 Volt Units
4 Connect the power cord to the appropriate type of
electrical outlet.
Power Up the Unit
5 Turn on the water supply valve.
6 Make sure that the circuit breaker supplying power to
the dispenser is on.
7 Turn the toggle switch on the back of the dispenser to
UIF0/QPTJUJPO5IFXBUFSUBOLXJMMTUBSUUPmMM8IJMF
UIFUBOLJTmMMJOHJOTQFDUUIFXBUFSTVQQMZMJOFGPS
leaks.
5IF45018"4)MJHIUDPNFTPOXIJMFUIFUBOLJT
mMMJOHBOEUIFXBUFSJTIFBUJOHVQ
WARNING: Connect the power cord to the
appropriate type and size electrical outlet. If the
electrical outlet is not compatible with the power
cord, have it upgraded by a licensed electrician.
Do not modify the power plug. Do not use an
FYUFOTJPODPSE%POPUVTFBQPXFSDPSEQMVHUIBU
is damaged.