Power Up the Brewer
14 Turn on the water supply valve.
15 On units with a power plug, connect it to the appropriate
electrical outlet.
11 If the power cord will be connected directly to the
junction box, connect the power cable wires to the
terminals in the junction box. See the ELECTRICAL
SCHEMATIC for the power supply requirements.
INSTALLATION INSTRUCTIONS II8
DECANTER/DISPENSER BREWERS, INSTALLATION INSTRUCTIONS 081519C
Connect the Brewer Wiring (cont.)
Brewers That Come With A Cord Attached
12 If not already installed, install the appropriate type of
power plug for your locality. Consult local electrical
codes to determine the approved type of power plug
for your region.
WARNING: Connect the power cord only to the
appropriate type and size electrical outlet. If it is not
compatible, either have the cord replaced or have
the electrical outlet upgraded by a licensed
electrician. Do not use an extension cord. Do not
use a power cord/plug that is damaged.
WARNING: Turn off power to the junction box at
the circuit breaker panel before connecting the
power cable to the brewer. Lock out and tag the
circuit breaker.
Power cable from brewer
Connect the Bag-in-Box (BIB) Sweetener -
Units Equipped for Brewing Sweet Tea Only
13 Connect two bag-in-box (BIB) sweeteners to the
brewer sweetener supply hoses as instructed in the
OPERATING INSTRUCTIONS section. Connecting two
bags allows the brewer to continue operating if one
bag runs out. The length of the tubing from the transfer
valve to each bag-in-box connector is should be 1 ft.
(30.5 cm) to 3 ft. (91.4 cm). The total length of tubing
from each bag-in-box connector to the brewer can be
up to 6 ft. (183 cm) under optimal conditions.
To Next Page
Loading...
Need help?
General
