OPERATING INSTRUCTIONS OI6
5101&3"5*/(*/4536$5*0/4øø 072320B
Brewing Instructions
2 Center an empty dispenser
under the brew basket. Make
sure the satellite is pushed
all the way back against the
front cover and is making
contact with the electrical
socket. For best results, pre-
heat the dispenser with 12
oz. (350 ml) min. of hot water
for 1 min. then dump out.
3 *OTFSUBDMFBOQBQFSmMUFSJOUP
the brew basket.
4 Fill with the proper amount
of ground coffee. Level the
DPGGFFJOUIFmMUFS
5 4MJEFUIFmMMFECSFXCBTLFU
into the brew rails under the
control panel. Slide it all the
way back until it stops.
The brewer will brew coffee or tea based on the settings programmed into the universal control module (UCM). To
change the settings, see the PROGRAMMING GUIDE section.
1 The brewer should be ON.
$POmSNUIJTBUUIFSFBS
toggle switch. “Ready to
brew” should be on the
display. If the brewer is
connected to an inter-lock
grinder, the grinder should
be on. When inter-lock
connection is made, grind
coffee at this time.
6 Press the brew button.
Brewing will begin
immediately.
WARNING - TO AVOID SCALDING, AVOID SPLASHING. Keep body parts clear of the brewer during
brewing. Do not remove the brew basket while “Brewing” appears on the display.
The G3 ThermoPro Brewer is factory preset for optimal performance.
To Next Page
Loading...
Need help?
General
