Curtis ThermoPro G4 Series - Programming and Configuration Guide; Touchscreen Control Module Overview; Manual Programming Mode Guide

PROGRAMMING GUIDE PG1
2 The ACCESS CODE screen will appear. The
default pass code is 1 2 3 4. Once the code is
entered, press OK. The MAIN MENU screen will
appear. The access code can be reset in the
Control Settings sub-menu, under Passwords.
Manual Programming Mode
1 5BQUIFXIJUF$VSUJTMPHPPOUIFUPVDITDSFFOmWFUJNFTUPFOUFSQSPHSBNNJOHNPEF
3 The MAIN MENU screen contains a series of sub-
NFOVJDPOT5IFJDPOTWBSZCBTFEPOUIFNPEFM
selected under the Model Select sub-menu. For
UIFCSFXFSUPPQFSBUFQSPQFSMZUIFNPEFMTFMFDUFE
must match the model series on the brewer model
OVNCFSMBCFMBGmYFEUPUIFPVUTJEFPGUIFNBDIJOF
(130(3"..*/((6*%&ø  H
Status lights
Brew Buttons
Curtis logoHome Undo Scroll
left/right
Return to
previous
Control symbols - all
symbols may not be
present at the same
time
Display view varies
with model
Touchscreen Control Module Overview
5IFUPVDITDSFFOUVSOTPOXIFOFWFSUIFSFBSUPHHMFTXJUDIJTPO5IFTZNCPMCVUUPOTPOUIFTDSFFODPOUSPM
PQFSBUJPOBOEQSPHSBNNJOH1SFTTJOHUIFPOTDSFFOTZNCPMTBOECVUUPOTXJUIZPVSmOHFSUJQBDUJWBUFTUIFWBSJPVT
functions. The default screen, as well as additional control buttons are shown below.
There are two methods for changing the default settings on G4 brewers. The settings can be programmed
NBOVBMMZVTJOHUIFCSFXFSUPVDITDSFFOTFFCFMPXPSBVUPNBUJDBMMZVTJOHUIF64#6OJWFSTBM4FSJBM#VTEBUB
port on the side of the brewer (see Automatic Programming - USB).