Cuttermasters Professional JXT - Page 10

www.cuttermasters.com - Toll Free (800) 417 2171
CUTTERMASTER Professional JXT User’s Manual
Page 10
The DC Variable Speed Motor and Control is reversible, variable speed and produces ten times
the torque than the standard 1/3HP AC motor . This helps eliminate tool burning by facilitating heavy.
Cuts at greatly reduced RPM, cutting grinding times in half on some tools. Read the appendix KB
Control Board Manual before operating. The internal circuit board trim pots have been set according
to our preferences.
The CM-02A Air Spindle:
Note: Always have air supplied to the air spindle when being moved or in use. Check the air spindle
components and wipe them completely free from dust and oil using acetone or a solvent that does not
leave a residue (See Cleaning Section).
Hook up shop air to the air spindle. There must be clean dry air present (must have an air dryer on
theline)itcanbeusedwithoutadditionalltrationandmoisturecontrol.
Theairspindleusesonetotwocfmat80to100psi.Aregulatorltermayhaveshippedwiththema-
chine(CM-01P,CM-02Rdoesnotmountalterbutitcanbemountednearthemachineifrequired).
ThelterassemblyisnotattachedtotheCM-02Rairspindlebecausethereareadjustmentdevices
that need to be accessed and the spindle must be free to more.
The height of the stylus that the end mill rides on should be kept to the same height as the center line
of the air bearing spindle. Using a 3/8 5C collet mount the 3/8 Half Pin in the air bearing to set the sty-
lus height. The face points down, parallel with the x table top face. Raise the stylus to touch the face
ofthecenternderandlockthenutatthestylusbase.