31
Use DoP for digital output – If your device does supports native DSD in DoP format.
Use PCM for digital output – If your device doesn’t support native DSD.
Control Bus
If your device is connected to a Cambridge Audio amplifier using a control bus connector, volume commands can be sent directly to the amplifier. For
more information, please refer to the Getting Connected section of this manual under ‘Control Bus’.
Pre-amp
With Pre-Amp mode enabled the volume of the device's line output can be controlled using the app, the remote or the rotary dial.
For more information see our FAQ.
Volume Limit
This sets the maximum volume that other streaming services like AirPlay 2, Spotify, TIDAL Connect and Chromecast built-in can set. The front panel,
remote control and StreamMagic app volume controls can override this setting.
Early Update
Early Updates provide the opportunity to receive pre-release firmware for your CXN (V2). To subscribe to Early Updates, select On, and to opt out
select Off.
Note: Information on what is included in the current early update for the CXN (V2) can be found here.
Firmware
This will check for and apply any new firmware available for your network player. You can also check for new updates on the info screen. When left in
network standby overnight your player will check and apply any new updates.
Note: Your network player must be connected to the internet to carry out firmware updates. It is recommended that you keep your network player
connected to ensure optimal performance. Information on the latest firmware version for the CXN (V2) can be found here.
Factory Reset
This will return your player to its factory settings.
You may perform a factory reset via the front panel controls/remote control (Home > Settings > Factory Reset). Or, via Settings in the StreamMagic
app.
Note: Returning the player to its factory settings will delete all previously saved network settings and presets.
To Next Page
Loading...