14
e e
h
REMOVING THE SEAT COVER
REMOVING THE COVER FROM THE HEADREST FLAP
REMOVING THE COVER FROM THE HEAD SUPPORT
The cover of the infant seat consists of four parts (Headrest ap, headrest, shoulder
part cover, booster cover and/or seat surface cover). The four covers of the seat are
tted into the cover attachment channels on the edge of the infant seat and are held
in position at several places by press-studs (see image).
Once all studs have been released, the single parts of the cover can be removed
from the cover attachment channels.
Pull the opening of the cover over the adjustment lever so that the cover does not get
jammed on the lever when pulling it up to remove it.
Release the two press-studs at each side of the rear of the shoulder area. Pull the
cover out of the cover attachment channel.
In order to put the covers back on the seat, proceed in the reversed order as
removing them.
WARNING! The child car seat must never be used without the cover.
REMOVING THE COVER FROM THE SHOULDER PART
Pull the cover out of the cover attachment channel.
To Next Page
Loading...
