6. Secure the center (elevation motor) cover.
A. Place the center cover in position.
B. Using a Phillips head screwdriver, attach the
two screws removed in step 5A.
7. Test the unit for proper operation.
A. Connect the power cord into the power inlet and
the power outlet.
B. Turn the main power switch to the on (I)
position.
C. Operate the unit at all levels to verify proper
operation.
D. Turn main power switch off to verify it is wired
properly.
10 Trotter Drive Medway, MA 02053 • 508-533-4300 • FAX 508-533-5183 • www.cybexinternational.com • techhelp@cybexintl.com
techpubs@cybexintl.com • Copyright © 2008, Cybex International, Inc. All rights reserved • 600A-307 A • March 2008
Cybex
®
and the Cybex logo are registered trademarks of Cybex International, Inc.
Arc Trainer
®
and its mark are registered trademarks of Cybex International, Inc.
To Next Page
Loading...
