B. Using a 7/32” Allen wrench, attach the
two BHSCS (C) securing the handle
assembly (A) to the console assembly.
See Figure 3.
C. Place a drop of loctite (E) on the BHSCS
(D) and another drop inside the shaft into
where the BHSCS will be tightened.
D. Using a 7/32” Allen wrench, attach the
BHSCS/loctite (D) and pivot shaft retainer
to each side of the handle assembly.
See Figure 2.
5. Test the unit for proper operation.
Cybex
®
and the Cybex logo are registered trademarks of Cybex International, Inc.
Arc Trainer
®
and its mark are registered trademarks of Cybex International, Inc.
10 Trotter Drive Medway, MA 02053 • 508-533-4300 • FAX 508-533-5183 • www.cybexinternational.com • techhelp@cybexintl.com
techpubs@cybexintl.com • Copyright © 2008, Cybex International, Inc. All rights reserved • 620A-326 A • March 2008
To Next Page
Loading...
