Cybex Eagle 11040 Leg Press Owner’s Manual
Assembly
Page 4-1
4 - Assembly
TOOLS REQUIRED
7/32” Allen wrench•
3/4” Allen wrench•
9/16” Wrench •
External snap ring pliers•
Phillips screwdriver•
Medium weight automotive engine oil•
Torque Wrench •
NOTE: Two people will be required for this procedure.
NOTE: It is the responsibility of the facility owner/owner of the equipment to ensure that
there is appropriate clearance around each machine to allow for safe use and passage.
1. Read and understand all instructions thoroughly before starting any of the procedures
listed on this instruction sheet.
2. Verify you have received the appropriate confi guration.
Verify that you received the correct color machine that you ordered.A.
Verify you received weight plates and weight plate decals.B.
Verify you received the Cybex Eagle Leg Press Owner’s Manual. C.
Verify you received the warranty sheet.D.
3. Move to desired location.
Note the diminsions of the machine:A.
Idle - 68 L x 42 W x 75 H inches
172.72 L x 106.68 W x 190.5 H cm
In use - 95 L x 42 W x 75 H inches
241.3 L x 106.68 W x 190.5 H cm
Machine Weight with weight stack - 1031 lbs. (467.65 kg)
Determine if you can move your machine through the required doorway(s).B.
If the machine fi ts through the the doorway(s), move machine to desired location and skip to step 5. C.
If weight stacks need to be installed proceed to step 6.D.
If the machine does not fi t through the door-way(s) then see step 4. E.
4. Doorway Instructions.
NOTE: If your machine fi ts through the doorway then skip step 4.
If your machine does not fi t through the doorway, then perform step 4.
Carefully remove each (standard) cone-shaped shipping support using a 3/4” socket or wrench.A.
Make a note of the current belt routings and connections. This will assist you in reinstalling them properly. B.
Cut Shipping tie securing top weight.C.
To Next Page
Loading...
Need help?
General
