7
EN
1
Assembling the seat unit: put the seat unit into the ttings on the frame either before or after
attaching the bumperbar. When the seat unit is tted you can hear a „click“ sound on both sides
of the frame. The seat unit can be used in both directions: forward and reward facing.
Assembling the bumperbar: place the bumperbar in position by pushing downwards in the
direction of the arrows. To remove the bumperbar, press the button
b
and remove your child
with ease.
5
Put your child in the pushchair. make sure the shoulder belts are positioned correctly over your
childs shoulders and put both plastic clamps in the buckle till you hear a „click“. Press it left side
and right side to close the harness buckle.
By pressing both buttons on the left and right, you will release the harness buckle and can
open it again.
3
2
You can remove the seat unit by pushing the release buttons a on both sides.
8
The seat unit backrest can be adjusted to three dierent positions. To adjust the backrest, press
the button to move it to the desired position.
6
Fitting the hood: the hood comes ready to use in the box. Attach it by putting the hood clasps on
to the frame and pressing them together.
To remove it, open the zipper and push the hood clasps upwards away from the frame.
INSTRUCTIONS
Important — Keep these instructions for future reference.
Compatible with BIMISI & LEOTIE
Warnings, safety instructions, maintenance, disposal and guarantee can be found in the warnings
booklet.
The hood is multifunctional. It can be unzipped and opened completely to cover a wider area.
There is a viewing window in the hood to allow you to see your child.
7
To adjust the belt system in length or shorten it tear the belt through the clip.
4
To Next Page
Loading...
Need help?
General
