25
REMOVING THE SEAT COVERS
The seat cover consists of four parts which are attached to
the seat with velcro, snaps or button holes. Once you have
released the fasteners, the cover parts can be removed. To
remove the covers, please follow the instructions below:
1. Move the Headrest to its highest position.
2. Undo the snap behind the bottom of the Reclining
Headrest pad, then undo the velcro at the back.
3. Pull the cover around the Headrest Recline Handle,
then pull up to remove the cover.
4. Open the two snaps on both sides of the rear shoulder
area underneath the Headrest. Then pull the cover off
away from the attachment channel.
5. Begin pulling the cover out of the cover attachment
channel at the shoulder area and work your way
around until the shoulder cover is removed
6. Unsnap the two snaps at the bottom front of the
Booster Base, then unsnap the two snaps at the back
of the Booster Base.
7. Begin removing the cover from the back and over the
armrests and along the seat surface.
8. Finally unsnap the two snaps on the top back of the
booster.
REINSTALLING THE SEAT COVERS
To install the seat covers, follow the removal instructions
above in reverse.
FABRIC COVERS
3
5
7
4
6
8
To Next Page
Loading...
