5
EN
Thank you for deciding on the Solution S i-Fix when choosing your car seat.
Carefully read this User guide before installing the car seat in your vehicle and
always keep the guide to hand in the designated User guide storage
compartment (1).
IMPORTANT INFORMATION
•
Without the approval of the Type Approval Authority, the vehicle seat may
•
In order to keep your child properly protected, it is absolutely essential that
you use the car seat as described in this user guide.
•
This car seat may only be installed on vehicle seats which are approved for
the use of child restraint systems according to the vehicle manual.
•
Only suitable for vehicle seats with automatic three-point belts approved in
accordance with UN regulation No.16 or a comparable standard.
•
Do not use any load bearing contact points other than those described in the
instructions and marked on the child restraint.
•
The full surface of the backrest of the car seat must make contact with the
backrest of the vehicle.
•
The shoulder belt must run upwards and back at a recline. It must never run
forward to the upper belt point in your vehicle.
•
The vehicle belt buckle must never cross the belt guide of the seat. If the
belt whip is too long, the car seat is not suitable for use in this position in the
vehicle. In case of doubt please contact the child restraint manufacturer.
•
The three-point vehicle belt must only be passed through the designated
routings. The belt routings are described in detail in this manual and are
marked in green on the car seat.
•
The lap belt must run as low as possible across your child’s groin to have
•
Before each use make sure that the automatic three-point vehicle belt is
•
•
The car seat must always be secured correctly with the vehicle belt in the
vehicle even when not in use.
•
Always ensure that the car seat is never jammed when closing the vehicle
door or adjusting the back seat.
•
For the car seat to provide the best possible protection, always use the
Linear Side-impact Protection (L.S.P.) to the nearest door side.
•
If using the car seat on the middle seat of the vehicle's back bench, the
Linear Side-impact Protection (L.S.P.) must never be folded out.
•
The car seat has also been tested and approved for use without the Linear
Side-impact Protection (L.S.P.) folded out.
•
secured. Otherwise, they may be thrown within the vehicle, which could
cause fatal injuries.
•
The car seat must never be used without the seat cover. Ensure that only
an original CYBEX seat cover is used, as the cover is a key element of the
seat’s function.
•
Never leave your child unattended in the vehicle.
•
The parts in the child restraint system heat up in the sun and could
direct sun exposure.
•
the naked eye. Please replace the car seat after an accident. In case of
doubt, please consult your dealer or the manufacturer.
•
Do not use this car seat for more than 9 years. The car seat is exposed to
high stress during its product life span, which leads to changes in the quality
of the material with increasing age.
•
The plastic parts can be cleaned with a mild cleaning agent and warm water.
Never use harsh cleaning agents or bleaches!
•
On some vehicle seats made of sensitive materials, the use of car seats may
leave marks and/or cause discolouration. To prevent this, you can place a
blanket or towel or similar underneath the car seat to protect the vehicle seat.
CERTIFICATION
UN R129/03
CYBEX Solution S i-Fix
100 – 150 cm
Recommended from
approx. 3 years to 12 years
SOLUTION S I-FIX
Specific Vehicle
Booster Seat
100-150 cm
030035
UN Regulation
No. 129/03
Cybex GmbH
Riedingerstr. 18, 95448 Bayreuth
Germany
To Next Page
Loading...
Need help?
General
Weight and Dimensions
