AlterPath ACS Command Reference Guide 245
Power Management with AlterPath™ PM Integration
pmCommand command
Through pmCommand command, the administrator has access to other options beyond
the menu options, because he will be accessing the IPDU itself. The administrator must
have a good knowledge of the AlterPath PM command set to use it.
There are two ways to use this command. If only the IPDU port is passed as an argument,
it will appear in a prompt where the administrator can write the command. Otherwise,
the arguments after the IPDU port will be considered the PM command.
Syntax:
pmCommand <IPDU port> [<command>]
For example:
[root@CAS root]# pmCommand 1
-----------------------------------------------------------------------
Cyclades Corporation
Power Management Command Prompt v1.1
-----------------------------------------------------------------------
Power Name: PM
[PM]
The following are examples of some things which can be done through this
command.
Listing the commands available for the AlterPath PM
[root@CAS root]# pmCommand 1 help
•
exit ----------------------- Exit
•
help ----------------------- Show this help
•
menu ---------------------- Start the menu driven text interface(pm)
•
whoami --------------------Display the username currently logged in
•
getname -------------------Get the name of the server
•
on ------------------------- Turn on outlets
•
off ------------------------ Turn off outlets
•
cycle ---------------------- Power cycle outlets
•
lock --------------------- Lock outlets in current state
•
unlock -------------------Unlock outlets
•
status --------------------Display state of the outlets
•
interval ------------------ Set/read the power up interval
•
name -------------------- Name an outlet
•
current ------------------ Set/Read/Reset the current
•
temperature ------------- Set/Read/Reset the temperature
To Next Page
Loading...
