AlterPath ACS Command Reference Guide 315
Profile Configuration
•
parity - To configure the parity. Valid values are:
none
,
even
and
odd
.
•
protocol - This parameter configures the protocol that will be used to connect to
the ports. Valid values are:
bidirectionaltelnet,
consoleraw
,
cslip
,
ppp
,
slip
,
telnet
,
consolessh
,
local
,
pppnoauth
,
sshv1
,
consoletelnet
,
pm
,
rawsocket
,
sshv2
.
•
speed - Configure the serial port speed. Valid values are:
300 1200 2400 4800 9600 14400 19200 28800
38400 57600 76800 115200 230400 460800 921600
•
stopbits - This parameter configures the number of stop bits.
Valid values are: 1 and 2.
Other State Parameters:
Other state configurations are under the menu:
cli>config physicalports <'all' or range/list[1-4]> other
Under this menu you can configure the following parameters:
•
authbio - Configure if an AlterPath Bio authentication scanner is used.
•
banner - This parameters sets the banner that will be issued when the user connects
to the port. Strings must be entered between “” (double quotes).
•
breakinterval - To set break interval in milliseconds (ms).
•
breaksequence - To set the break sequence. Usually a character sequence, ~break
(Ctrl-b)
•
host - IP address of the device you are connecting to.
•
idletimeout - This parameter configures idle timeout in minutes.
•
portip - To configure an ip alias to the serial port.
•
sttyoptions - To configure stty parameters.
•
tcpkeepalive - To configure pool interval in milliseconds (ms).
•
tcpport - To configure socket port number. Four digit values are valid for this
parameter. Eg.: 7001.
•
terminaltype - The terminal type when using a TS profile for connecting to a host
system.
•
winems - Enables/Disables windows EMS.
To Next Page
Loading...
