Rear Handle 29.9 41.9 11.2
Motor: Alternating current, Universal, Semi-Enclosed 24-bar commutator
Electric Cord: 6' long, Non-Marking, 18/3 SJT or 8' long, CEE 7/7
Housing: Heavy-duty cast aluminum
Listing/Approvals: European Community - Model 5CE
Testing Labs: TÜV, Components Reliability and Safety - Model 5CE
• Vibration testing per ISO 8662-1:1986
SAFETY INSTRUCTIONS
WARNING: When using electric tools, basic safety precautions should always be followed to reduce the risk of fire, electric shock,
and personal injury, including but not limited to the following:
-READ ALL INSTRUCTIONS-
1) GROUNDING INSTRUCTIONS FOR MODEL 5 & 5C
The Model 5 & 5C Polisher/Sander should be grounded while in use to protect the operator from electric shock.
This tool is equipped with an approved three-conductor cord and three-prong grounding type plug to fit the proper grounding type
receptacle. The green conductor wire in the cord is the grounding wire. NEVER CONNECT THE GREEN WIRE TO A LIVE
TERMINAL.
If there is any doubt as to whether the wall receptacle is properly grounded, the customer should have it checked by a qualified
electrician.
DO NOT UNDER ANY CIRCUMSTANCES CUT OR REMOVE THE THIRD (GROUND) PRONG FROM THE POWER CORD
PLUG.
3
To Next Page
Loading...