STEAM/HOT WATER ILLUSTRATION
BEFORE THE FIRST USE
• After water stops dispensing, empty the water in drip tray or in the cup.
• Thoroughly clean the detachable parts of the whole machine with warm water.
NOTE:
Do not extend any parts of your body closed to portafilter and steam tube
to avoid scald during brewing hot water.
Before the first use or the machine has not been used for a long time, you should
follow below steps to rinse and warm up the internal pipes of the machine.
•
•
•
•
•
•
Check and ensure that all accessories are complete and not damaged.
Fill the water tank with clean water, and water level should not exceed the MAX
position.
Align the portafilter with portafilter bracket (no coffee powder is placed at this
moment), and rotate the portafilter counterclockwise to lock it tightly (place a
single-cup or double-cup filter as needed).
Put a cup on the drip plate, plug in the appliance, press “ ” button and the
appliance enters into the preheating condition, after finish preheating, the
appliance will enter into the standby mode.
Turn the knob to “ ”, after a while, some steam will flow out of the steam
tube. The steam tube shall align with the drip tray or a cup can be used for
collecting the steam or hot water.
Press “ ” or “ ” button to clean the pipes in the machine, use a cup to
collect the water to avoid any scald.
- 5 -
To Next Page
Loading...
Need help?
General