Cygnus 3 - Deep Coat Function

M4-CYG3-M-ENG_Iss2.doc
Cygnus 3 Operating Manual
31
3.
Scroll down to ALARM
4.
Press the EDIT key to change
the ALARM setting from On to
Off:
When the ALARM is ON the
MIN VALUE setting is shown.
5.
To change the MIN ALARM value
scroll down to MIN VALUE
Then press the EDIT key to
change the MIN ALARM setting.
6.
Use the number keys to enter in
the minimum thickness value as
required.
Press the OK key to save the
new MIN ALARM value.
7.
The gauge will automatically go
back to the measuring screen.
Deep Coat Function
The Gauge can normally measure metal thickness through
protective coatings up to 6 mm thick
2
, however using the Deep-
Coat function the Gauge can measure through coatings up to 20
mm thick
2
.
2
Depending on the properties of the coating and its velocity of sound.