Cygnus 3 - Page 60

Cygnus 3 Operating Manual
M4-CYG3-M-ENG_Iss2.doc
60
13.
The gauge is now ready to start
logging thickness measurement
results
Note the middle function key
name is now LOG – this key is
used to log the thickness
measurement.
14.
The number of thickness
measurements that have been
logged is shown on the right of
the screen followed by the
number required in the
template.
The name of the current
measurement point is shown on
the left
15.
To log the displayed thickness
measurement press the LOG key
The gauge will give a BEEP and
the display will inverse. When
the data has been saved the
green LED will flash
16.
The gauge is now waiting for the
next thickness measurement
The name of the current
measurement point has moved
to the next location