What to do if Cynosure Medical Equipment shows Low Trans?
If your Cynosure medical equipment displays a 'Low Trans' message, this indicates that the fiber, handpiece, or focus lens is damaged and needs replacement.
Why does Cynosure Medical Equipment show Fuse Open?
A 'Fuse Open' error on your Cynosure medical equipment suggests a blown capacitor bank fuse or a shorted dump circuit, requiring professional service.
What to do if Cynosure Medical Equipment shows No High Voltage?
If your Cynosure medical equipment displays 'No High Voltage', it indicates that the capacitor bank or HVPS wire is shorted, or there's no read back voltage. This requires service.
What causes Heater Fault in Cynosure Medical Equipment?
A 'Heater Fault' in Cynosure medical equipment is caused by an open thermostat or heater, or a blown heater fuse. This issue needs service.
What does No Simmer YAG mean on Cynosure Medical Equipment?
A 'No Simmer YAG' error on Cynosure medical equipment indicates a broken lamp or a blown fuse, and the device needs service.
What to do if Cynosure Medical Equipment shows Dump Fault?
A 'Dump Fault' on Cynosure medical equipment may be caused by a fuse fault at power up, the dump being always on (possibly due to a shorted dump, failed dump TX, or HVPS failure), or the dump not working (possibly due to broken fiber connections to the cap bank or a disconnected/failed HVPS). This requires service.
Why does Cynosure Medical Equipment show Coolant Sensor Fault?
A 'Coolant Sensor Fault' in Cynosure medical equipment is due to an open thermistor sensor or the sensor being unplugged. This issue needs service.
What does YAG Cal Failed, Energy Low mean for Cynosure Medical Equipment?
A 'YAG Cal Failed, Energy Low' message on Cynosure medical equipment means the YAG cal port energy is too low to use, requiring service.
What causes YAG Calibration Error in Cynosure Medical Equipment?
A 'YAG Calibration Error' in Cynosure medical equipment indicates an incorrect Resonator Port or Cal Port sensor calibration, requiring service.
What does Open Shutter Fault mean on Cynosure Medical Equipment?
An 'Open Shutter Fault' on Cynosure medical equipment indicates that the safety shutter is stuck closed. Do not use the laser until it has been serviced.
General| Wavelength | 585 nm (Pulsed Dye), 1064 nm (Nd:YAG) |
|---|---|
| Laser Type | Pulsed Dye and Nd:YAG |
| Spot Size | 2 mm, 3 mm, 5 mm, 7 mm, 10 mm |
| Fluence | 5 - 600 J/cm² (Nd:YAG) |
| Electrical Requirements | 200-240 VAC, 50/60 Hz |
| Display | Touchscreen |
| Energy Output | Pulsed Dye: Up to 20 Joules, Nd:YAG: Up to 60 Joules |
| Cooling System | Integrated Dynamic Cooling Device (DCD) |
To Next Page
