14
Once in the command line interface (CLI) type "telnet", a space,then the IP
address of the unit you wish to control, a space and "23", then hit enter.
Note: The IP address of the Matrix can be displayed on the device's LCM
monitor by pressing the Menu button twice.
This will bring us into the device which we wish to control. Type "HELP" to
list the available commands.
Type “IPCONFIG” To show all IP congurations. To reset the IP, type “RSTIP”
and to use a set static IP, type ”SETIP” (For a full list of commands, see
Section 6.7).
Note: Any commands will not be executed unless followed by a carriage
return. Commands are not case-sensitive. If the IP is changed then the IP
Address required for Telnet access will also change accordingly.
To Next Page
Loading...