CYPRES 2 - Page 23

- CYPRES 2 User’s Guide - page 23
CYPRES can be assembled into rigs with exist-
ing setups. Please refer to the harness/container
manufacturer if in doubt.
It is necessary to place the processing unit into the
pouch so that the cables lay at on the bottom of
the pouch. Control unit cable and cutter cable(s)
must be placed without tension.
Excess cable is stowed in the flat part of the
pocket underneath the velcro-adjustable ap. If
you have to stow both the thinner cutter cable and
the thicker control unit cable, be sure to place the
thicker cable so that it lays on top of the thinner
one. Cables should be placed in a circle in order
to avoid twists. Always avoid pulling, bending,
twisting, or kinking the cables.
right
wrong
- cables not at on
bottom
- unit is inserted up
side down
- thin cable on top
of thicker cable
- cable is bent
Inappropriate installation can result in inappropriate
container opening performance.
That can cause injury or death. Never install a CYPRES
by trial and error.
Removal of CYPRES can be done by the owner
without any problems. Do not pull on the cables,
instead push the processing unit, cutter and control
unit from their keepers.