CYPRES 2 - 4.6 CYPRES 2 and Water jumps

page 36 - CYPRES 2 User’s Guide -
CYPRES 2 allows water jumps without removal of
the unit. CYPRES 2 is waterproof for a duration of
up to 24 hours down to a water depth of 8 feet (2.5
meters). This is achieved through a water-resistant
casing, sealed plug connections, a sealed cutter, a
sealed control unit, and a special lter. The lter al-
lows precise measurement of the air pressure and at
the same time keeps water away from the inside of
the unit. As long as there is no contact with water,
the lter never needs to be replaced by the user.
After water contact, the unit must be switched off
immediately after exiting the water. The lter must
be replaced before next use.
The CYPRES 2 lter changer tool is made from
stainless steel, specically for the purpose of lter
removal and replacement. Filter replacement (see
chapter 4.7) can be done by your rigger (packer).
After water contact, the rig and the reserve must
be dried according to the manufacturer’s instruc-
tions. After that the rig and CYPRES 2 with the
new lter can be used again.
4.6 CYPRES 2 and Water jumps