Cyrus DluOS Classic STREAM - Important - Read before Making any Connections; Connecting Analogue Audio; Connecting Digital Audio; Network Connection

6
Cyrus Classic Stream User Instrucons
Connecng analogue audio
• Connect a stereo audio interconnect cable between
the Classic STREAM analogue output and the analogue
input of a pre-amplier (e.g. Classic PRE) or integrated
amplier (e.g. Classic AMP).
Connecng digital audio
• Using a suitable Toslink opcal or digital phono
interconnect, connect between the Classic STREAM
digital output and the digital input of a pre-amplier
(e.g. Classic PRE) or integrated amplier (e.g. Classic
AMP).
Network connecon
• Wi: The Classic STREAM uses an innovave internal
antenna so no external antenna is needed.
• Wired: Connect an RJ-45 network cable from your
router to the network socket on the rear of the Classic
STREAM.
Download and install the BluOS app to your device.
bluesound.com/downloads
Follow the instrucons in the “Add A player” wizard in the
BluOS app to locate and connect your Stream-XR to the
network.
Factory reset
While powered up, either press and hold the reset buon
(located on the rear of the Stream-XR) for 10 seconds, or
select Factory Reset from the System menu.
MC-BUS system (oponal)
By using the MC-BUS connecon, a highly funconal
integrated system with full remote control may be set up.
This feature is usable if you own a Cyrus amplier. Refer
to the relevant product handbook for MC-BUS wiring
instrucons.
External power supply - PSX-R2
The PSX-R2 is a unique DC power supply that will upgrade
the sonic performance of compable products in the Cyrus
range.
CAUTION:
• Disconnect both the PSX-R2 and Classic STREAM from
the mains.
• Plug the mul-pin cable from the PSX-R2 into the
PSX-R2 socket on the back panel.
• Connect a mains supply to both units.
NOTE: Connecon of a PSX-R2 is detected automacally, so
no internal adjustments are required.
Connecng to the AC mains supply
Connect the socket on the AC Power cable to the power
inlet on the rear panel of the streamer. Now connect the
cable to a suitable AC power point.
NOTE: The means to disconnect this product from the
mains supply is the mains plug. Ensure that the mains plug
is accessible at all mes.
To avoid possible damage to your audio system, it
is essenal to disconnect all system components
from the mains supply before connecng or
disconnecng audio interconnects.
Important – read before making any connecons