Need help?Do you have a question about the D.A.S. EP Series and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Signal to Noise Ratio | > 100 dB |
| Frequency Response | 20 Hz - 20 kHz |
| Input Impedance | 20 kOhm Balanced, 10 kOhm Unbalanced |
| Protection | Thermal, short circuit, DC |
| Connectors Input | XLR |
| Connectors Output | Binding posts, Speakon |
Configuration options for amplifier parameters using rear panel mini DIP switches.
Configuration options for Stereo, Parallel, and Bridge modes for input signals.
Detailed guide to configuring amplifier settings using rear panel mini DIP switches.
Adjusting amplifier gain (dB) and selecting between Stereo and Bridge modes.
Setting maximum output voltage limits per channel for speaker protection.
Detailed output power figures for different impedance loads and bridged configurations.
Diagnosing and resolving issues where no audio output is present.
Troubleshooting steps for when the amplifier does not reach its maximum output level.
Identifying causes and solutions for audio distortion from the amplifier.
Resolving noise issues related to grounding, cabling, or power connections.
Interpreting protection indicators like MUTE and Temp LEDs and their causes.
To Next Page
