D.A.S. ps-800 User Manual

8
To operate in bridge mode, follow these steps:
1.Switch off the amplifier.
2.Turn volume control potentiometers on the front panel to minimum position (fully anticlockwise).
3.Connect input signal to channel A.
4.Set mode switch to “BRIDGE”.
5.Connect speakers as follows:
Connect (+) to red speaker terminal on channel A's output terminals
Connect (-) to red speaker terminal on channel B's output terminals
6. Turn volume control potentiometers on the front panel to maximum position (fully clockwise).
7. Control volume levels from the mixer or pre-amp only.
NOTE: We do not recommend using bridge mode with loads lower than 4 ohms.
APPENDIX A. Bridge Mode Operation
EN
Manual del Usuario /PS/User’s Manual

D.A.S. ps-800 Specifications

General

Brand	D.A.S.
Model	ps-800
Category	Amplifier
Language	English