DAP-1150 Quick Installation Guide
Configuring Local Area Network
1. Go to the Net / LAN page. If needed, change the IP address of the access
point's LAN interface and the mask of the local subnet in the IP
Address and Netmask fields. Then click the Save button.
2. By default, the DHCP server of the device is enabled. In the DHCP
server section, you can change the parameters of the DHCP server. As a
rule, the DHCP server should be disabled when the device is used in the
access point mode (select the Disable value from the Mode drop-down
list).
3. After specifying the DHCP server settings, click the Save button.
17
To Next Page
Loading...
