DCS-2670l
3
ENGLISH
MOUNTING THE CAMERA
Please refer to the steps below to assist you with mounting the camera. It is
recommended that you configure the camera before mounting.
Step 1:
Open a web browser and go to www.mydlink.com,
then sign into mydlink.
Step 2:
Select your camera from the device list, and your
camera’s Live View will appear.
After registering your DCS-2670L camera with a mydlink account in the
mydlink Lite mobile app, you will be able to remotely access your camera from
the mydlink website.
mydlink PORTAL
Step 1:
Place the baseplate where you want to position the
camera and use a pencil to mark the holes. You can
use the large holes for a removable installation, or
the small holes for a fixed one. Make sure the lock
arrow on the plate is pointing down.
Step 2:
Depending on the material of the wall or ceiling, use
proper tools to drill holes 25 mm deep with a 6 mm
drill bit where you marked. If the wall is made out of
concrete, drill the holes first, then insert the plastic
anchors to support the screws.
To Next Page
Loading...
