D-Link DCS-930L Setup Guide

D-Link Technical Support – How to record using mydlink camera's. Page 2 of 17
For this setup guide we will be using the DCS-942L to illustrate how you can record using
the D-Link D-ViewCam software application.
This document can be applied to all of the mydlink camera range, thus far it applies to
DCS-930L / DCS-932L and DCS-942L.
D-Link D-ViewCam Installation:
1. The D-ViewCam software is provided on the Installation CD-ROM. Insert the Installation
CD-ROM into your optical drive and allow it to autorun and or browse your optical drive
and double click on the 'autorun.exe' file. Allow it to run if asked for permission.
2. Click on the D-ViewCam (DCS-100) menu:
NOTE: Any prompts that require permission please click on 'Run', 'OK', 'Accept' and or
'Continue'.

D-Link DCS-930L Specifications

General

Maximum resolution	640 x 480 pixels
White balance	Auto
Minimum illumination	1 lx
Sensor type	CMOS
Optical sensor size	1/5 \
Digital zoom	4 x
Security algorithms	WEP, WPA, WPA2
Video motion detection	Yes
Cabling technology	10/100Base-T(X)
Supported network protocols	IPV4, ARP, TCP, UDP, ICMP, DHCP, NTP, DNS, DONS, SMTP, FTP, HTTP, PPPoE, UPnP, LLTD
AC input voltage	100-240 V
DC output current	1.2 A
DC output voltage	+5V
AC input frequency	50 - 60 Hz
Power over Ethernet (PoE)	-
Power consumption (typical)	2 W
Ethernet LAN (RJ-45) ports	1
Certification	FCC B, IC, C-Tick, CE
Placement supported	Indoor
Dimensions (WxDxH)	27.2 x 60 x 96 mm
Compatible operating systems	Windows XP / Vista / 7
Flash memory	4 MB
Internal memory	32 MB
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	20 - 80 %
Form factor	Cube

Weight and Dimensions

Weight	76.9 g