D-Link DCS-930L How To Connect

D-Link Technical Support – How to connect the DCS-932L wirelessly. Page 7 of 7
10. Now type in your correct wireless password into the Pre-Shared Key field, then press the Save Settings
button:
11. Now remove the Ethernet cable from the DCS-932L.
NOTE: When you disconnect the Ethernet cable the power LED will turn red, then come green again within
a few seconds.
12. Now after 30 seconds click on Maintenance > System and click the Reboot the Device button:
12. When the DCS-930L has completed the reboot process you will know that your connected wirelessly as
you should also be able to click on the other menu's in the DCS-930L Web Configuration and when viewing
the Live Video menu, moving objects should also be visible in the DCS-930L Web Configuration without
needing an Ethernet cable connected.

D-Link DCS-930L Specifications

General

Maximum resolution	640 x 480 pixels
White balance	Auto
Minimum illumination	1 lx
Sensor type	CMOS
Optical sensor size	1/5 \
Digital zoom	4 x
Security algorithms	WEP, WPA, WPA2
Video motion detection	Yes
Cabling technology	10/100Base-T(X)
Supported network protocols	IPV4, ARP, TCP, UDP, ICMP, DHCP, NTP, DNS, DONS, SMTP, FTP, HTTP, PPPoE, UPnP, LLTD
AC input voltage	100-240 V
DC output current	1.2 A
DC output voltage	+5V
AC input frequency	50 - 60 Hz
Power over Ethernet (PoE)	-
Power consumption (typical)	2 W
Ethernet LAN (RJ-45) ports	1
Certification	FCC B, IC, C-Tick, CE
Placement supported	Indoor
Dimensions (WxDxH)	27.2 x 60 x 96 mm
Compatible operating systems	Windows XP / Vista / 7
Flash memory	4 MB
Internal memory	32 MB
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	20 - 80 %
Form factor	Cube

Weight and Dimensions

Weight	76.9 g