Connecting Network Cable
The DES-1026G supports 10/100/1000Mbps Gigabit Ethernet and fiber
connections. It runs in full/half duplex transfer mode for 10/100Mbps and
full duplex transfer mode for 1000Mbps. Each port on the DES-1026G
supports Auto-MDI/MDI-X. Auto-MDI/MDI-X is a feature that eliminates
the need for worrying about using either a standard or crossover
cable—you can use either one—and allows any port to be an uplink port.
AC Power
The DES-1026G can be used with AC power supply 100~240V AC,
50~60 Hz. The power switch is located at the rear of the unit adjacent to
the AC power connector. The switch’s power supply will adjust to the local
power source automatically and may be turned on without having any or
all LAN segment cables connected.
To Next Page
Loading...
