DES-3028 DES-3028P DES-3052 DES-3052P Layer 2 Fast Ethernet Managed Switch
To remove a previously created rule, select it and click the
button. To add a new Access Rule, click the Add button:
Figure 9- 10. Access Rule Configuration window (Ethernet)
To set the Access Rule for Ethernet, adjust the following parameters and click Apply.
Parameters Description
Profile ID
This is the identifier number for this profile set.
Mode
Select Permit to specify that the Switch, according to any additional rule, forwards the
packets that match the access profile added (see below).
Select Deny to specify that packets that match the access profile are not forwarded by the
Switch and will be filtered.
Access ID (1-256)
Type in a unique identifier number for this access. This value can be set from 1 - 256.
Auto Assign – Checking this field will instruct the Switch to automatically assign an Access
ID for the rule being created.
Type
Selected profile based on Ethernet (MAC Address), IP address or Packet Content Mask.
•
•
•
Ethernet instructs the Switch to examine the layer 2 part of each packet header.
IP instructs the Switch to examine the IP address in each frame's header.
Packet Content Mask instructs the Switch to examine the packet header
Priority (0-7)
This parameter is specified if you want to re-write the 802.1p default priority previously set in
the Switch, which is used to determine the CoS queue to which packets are forwarded to.
Once this field is specified, packets accepted by the Switch that match this priority are
forwarded to the CoS queue specified previously by the user.
For more information on priority queues, CoS queues and mapping for 802.1p, see the QoS
section of this manual.
VLAN Name
Allows the entry of a name for a previously configured VLAN.
119
To Next Page
Loading...
