DES-3526 Layer 2 Fast Ethernet Switch
config vlan
<portlist> − A port or range of ports to add to, or delete from the
specified VLAN.
advertisement [enable | disable] − Enables or disables GVRP on the
specified VLAN.
Restrictions Only administrator-level users can issue this command.
Example usage:
To add 4 through 8 as tagged ports to the VLAN v1:
DES-3526:4#config vlan v1 add tagged 4-8
Command: config vlan v1 add tagged 4-8
Success.
DES-3526:4#
To delete ports from a VLAN:
DES-3526:4#config vlan v1 delete 6-8
Command: config vlan v1 delete 6-8
Success.
DES-3526:4#
config gvrp
Purpose Used to configure GVRP on the Switch.
Syntax
config gvrp [<portlist> | all] {state [enable | disable] |
ingress_checking [enable | disable] | acceptable_frame
[tagged_only | admit_all] | pvid <vlanid 1-4094>}
Description This command is used to configure the Group VLAN Registration
Protocol on the Switch. You can configure ingress checking, the
sending and receiving of GVRP information, and the Port VLAN ID
(PVID).
Parameters
<portlist> − A port or range of ports for which you want to enable
GVRP for.
all − Specifies all of the ports on the Switch.
state [enable | disable] − Enables or disables GVRP for the ports
specified in the port list.
ingress_checking [enable | disable] − Enables or disables ingress
checking for the specified port list.
110
To Next Page
Loading...
