DES-3526 Layer 2 Fast Ethernet Switch
config gvrp
acceptable_frame [tagged_only | admit_all] – This parameter states
the frame type that will be accepted by the Switch for this function.
tagged_only implies that only VLAN tagged frames will be accepted,
while admit_all implies tagged and untagged frames will be accepted
byt the Switch.
pvid <vlanid 1-4094> – Specifies the default VLAN associated with
the port.
Restrictions Only administrator-level users can issue this command.
Example usage:
To set the ingress checking status, the sending and receiving GVRP information :
DES-3526:4#config gvrp 1-4 state enable ingress_checking enable
acceptable_frame tagged_only pvid 2
Command: config gvrp 1-4 state enable ingress_checking enable
acceptable_frame tagged_only pvid 2
Success.
DES-3526:4#
enable gvrp
Purpose Used to enable GVRP on the Switch.
Syntax
enable gvrp
Description This command, along with disable gvrp below, is used to enable and
disable GVRP on the Switch, without changing the GVRP
configuration on the Switch.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To enable the generic VLAN Registration Protocol (GVRP):
DES-3526:4#enable gvrp
Command: enable gvrp
Success.
DES-3526:4#
111
To Next Page
Loading...
