DES-3526 Layer 2 Fast Ethernet Switch
Total Entries: 3
DES-3526:4#
reconfig
Purpose Used to connect to a member switch, through the commander
switch, using telnet.
Syntax
reconfig {member_id <value 1-32 | exit}
Description This command is used to reconnect to a member switch using telnet.
Parameters member_id <value 1-32> - Select the id number of the member
switch the user desires to configure.
exit – This command is used to exit from managing the member
switch and will return to managing the commander switch.
Restrictions Only administrator-level users can issue this command.
Example usage:
To connect to the MS, with member id 2, through the CS, using the command line interface:
DES-3526:4#reconfig member_id 2
Command: reconfig member_id 2
DES-3526:4#
Login:
config sim_group
Purpose Used to add candidates and delete members from the SIM group.
Syntax
config sim [add <candidate_id 1-32> {<password>} | delete
<member_id 1-32>]
Description This command is used to add candidates and delete members from
the SIM group by ID number.
Parameters add <candidate_id> <password> - Use this parameter to change a
candidate switch (CaS) to a member switch (MS) of a SIM group.
The CaS may be defined by its ID number and a password (if
necessary).
delete <member_id 1-32> - Use this parameter to delete a member
switch of a SIM group. The member switch should be defined by ID
number.
Restrictions Only administrator-level users can issue this command.
226
To Next Page
Loading...
