DES-3526 Layer 2 Fast Ethernet Switch
Example usage:
To add a member:
DES-3526:4#config sim_group add 2
Command: config sim_group add 2
Please wait for ACK...
GM Config Success !!!
Success.
DES-3526:4#
To delete a member:
DES-3526:4# config sim delete 1
Command: config sim delete 1
Please wait for ACK...
Success.
DES-3526:4#
config sim
Purpose Used to configure role parameters for the SIM protocol on the
Switch.
Syntax
config sim [{[commander {group_name <groupname 64> |
candidate] | dp_interval <30-90> | hold_time <sec 100-300>}]
Description This command is used to configure parameters of switches of the
SIM.
Parameters commander – Use this parameter to configure the commander
switch(CS) for the following parameters:
group_name <groupname 64> - Used to update the name
of the group. Enter an alphanumeric string of up to 64
characters to rename the SIM group.
dp_interval <30-90> – The user may set the discovery
protocol interval, in seconds that the Switch will send out
discovery packets. Returning information to the CS will
include information about other switches connected to it.
(Ex. MS, CaS). The user may set the dp_interval from 30 to
90 seconds.
hold time <sec 100-300> – Using this parameter, the user
may set the time, in seconds, the CS will hold information
sent to it from other switches, utilizing the discovery interval
227
To Next Page
Loading...
