DES-3526 Layer 2 Fast Ethernet Switch
To disable pausing of the screen display when show command output reaches the end of the page:
DES-3526:4#disable clipaging
Command: disable clipaging
Success.
DES-3526:4#
enable telnet
Purpose
Used to enable communication with and management of the Switch
using the Telnet protocol.
Syntax enable telnet <tcp_port_number 1-65535>
Description
This command is used to enable the Telnet protocol on the Switch.
The user can specify the TCP or UDP port number the Switch will
use to listen for Telnet requests.
Parameters
<tcp_port_number 1-65535> − The TCP port number. TCP ports
are numbered between 1 and 65535. The “well-known” TCP port
for the Telnet protocol is 23.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To enable Telnet and configure port number:
DES-3526:4#enable telnet 23
Command: enable telnet 23
Success.
DES-3526:4#
disable telnet
Purpose
Used to disable the Telnet protocol on the Switch.
Syntax disable telnet
Description
This command is used to disable the Telnet protocol on the Switch.
Parameters
None.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To disable the Telnet protocol on the Switch:
19
To Next Page
Loading...
