DES-3526 Layer 2 Fast Ethernet Switch
To download a configuration file:
DES-3526:4#download configuration 10.48.74.121 c:\cfg\setting.txt
Command: download configuration 10.48.74.121 c:\cfg\setting.txt
Connecting to server................... Done.
Download configuration............. Done.
DES-3526:4#
config firmware
Purpose Used to configure the firmware section as a boot up section, or to
delete the firmware section
Syntax
config firmware image_id <int 1-2> [delete | boot_up]
Description This command is used to configure the firmware section. The user
may choose to remove the firmware section or use it as a boot up
section.
Parameters image_id – Specifies the working section. The Switch can hold two
firmware versions for the user to select from, which are specified by
image ID.
delete – Entering this parameter will delete the specified firmware
section.
boot_up – Entering this parameter will specify the firmware image ID
as a boot up section.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure firmware section 1 as a boot up section:
DES-3526:4# config firmware section_id 1 boot_up
Command: config firmware section_id 1 boot_up
Success.
DES-3526:4#
show firmware information
Purpose Used to display the firmware section information.
Syntax
show firmware information
Description This command is used to display the firmware section information
55
To Next Page
Loading...
