Over: mpls
Revision: 17
Risk level: 3
Tag: Tunnels
22.11. Routing Information Protocol V1
RIP1 (Routing Information Protocol Version 1) is a Distance Vector routing protocol used in Inter
Autonomous Systems.
Family: Routing
Over: udp
Revision: 17
Risk level: 1
Tag: Application Layer Protocols
22.12. Routing Information Protocol V2
RIP2 (Routing Information Protocol Version 2) is an enhancement of the Version 1 of the protocol.
The main differences are the use of multicast instead of broadcast, and the support of variable
length subnet mask networks since subnets are now sent inside the updates.
Family: Routing
Over: udp
Revision: 17
Risk level: 1
Tag: Application Layer Protocols
22.13. Routing Internet Protocol ng1
RIPng (RIP New Generation) is intended to allow routers to exchange information for computing
routes through an IPv6-based network. RIPng is a distance vector protocol. RIPng should be
implemented only in routers since IPv6 provides other mechanisms for router discovery.
Family: Routing
Over: udp
Revision: 17
Risk level: 1
Tag: Application Layer Protocols
22.14. Spanning Tree Protocol
Spanning Tree Protocol allows the use of layer 2 networks with redundant paths by creating a
covering tree on which frames will be transmitted. The newly created topology of the network
(the tree) is loop free, thus preventing problems such as broadcast storm from occurring.
Family: Routing
Over: eth
Over: llc
Over: ppp
Revision: 17
Chapter 22: Routing
307
To Next Page
Loading...
