10D-Link DHP-309 AV User Manual
Section 2 - Installation
4. Adding More Adapters
If you would like to add more than 2 adapters, press the Simple Connect button of the additional adapter for no more than 2 seconds. The Power
LED will start blinking after you release the button. Then press the Simple Connect button of any adapter in your existing PowerLine network for
no more than 2 seconds. The Power LED will start blinking after you release the button.
Note: Both Simple Connect buttons must be pressed within 2 minutes. After above network security setup steps, your PowerLine network will be
securely congured with the same network encryption key.
To Next Page