DIR-320NRU Quick Installation Guide
Wired WAN Connection
1. Go to the Net / WAN page, select the WAN connection and click the
Delete button.
2. Click the Add button.
3. In the General settings section, in the Provider drop-down list, leave
the Manually value.
4. From the Connection Type drop-down list, select the needed value.
5. From the Port drop-down list, select the Ports:5 value.
6. Specify a name for your connection (any name for easier identification) in
the Name field.
7. If your ISP uses MAC address binding, in the Ethernet section, in the
MAC field, enter the MAC address registered by your ISP upon
concluding the agreement. To set the MAC address of the network
interface card (of the computer that is being used to configure the router
at the moment) as the MAC address of the WAN interface, click the
Clone MAC Address button ( ). To set the address of a device
connected to the router's LAN at the moment, select the relevant value
from the drop-down list (the field will be filled in automatically).
24
To Next Page
Loading...
