D-Link DIR-605 - Configure WPA-PSK and WPA2-PSK

28D-Link DIR-605 User Manual
Section 3 - Conguration
1. To enable WPA, WPA2, or WPA/WPA2, select
either Enable WPA Only Wireless Security (enhanced),
Enable WPA2 Only Wireless Security (enhanced), or
Enable WPA/WPA2 Wireless Security (enhanced).
2. Next to Cipher Type, select TKIP, AES, or Both.
3. Next to PSK/EAP, select PSK.
4. Next to Network Key, e n t e r a
passphrase. The key is an alpha-numeric
password between 8 and 63 characters long.
The password can include symbols (!?*&_) and
spaces. Make sure you enter this key exactly the
same on all other wireless clients.
5. Click Save Settings to save your settings. If you
are conguring the router with a wireless adapter,
you will lose connectivity until you enable WPA,
WPA2, or WPA/WPA2 (whichever of the three
options you have selected above) on your adapter
and enter the same network key as you did on the
router.