D-Link DIR-605 - DHCP Server Settings

31D-Link DIR-605 User Manual
Section 3 - Conguration
Check the box to enable the DHCP server on
your router. Uncheck to disable this function.
Enter the starting and ending IP addresses for
the DHCP server’s IP assignment.
The length of time for the IP address lease.
Enter the Lease time in minutes.
Enable DHCP
Server:
DHCP IP
Address Range:
DHCP Lease
Time:
DHCP Server Settings
DHCP stands for Dynamic Host Control Protocol.
The DIR-605 has a built-in DHCP server. The DHCP
Server will automatically assign an IP address to the
computers on the LAN/private network. Be sure to
set your computers to be DHCP clients by setting
their TCP/IP settings to “Obtain an IP Address
Automatically.” When you turn your computers
on, they will automatically load the proper TCP/IP
settings provided by the DIR-605. The DHCP Server
will automatically allocate an unused IP address from
the IP address pool to the requesting computer. You
must specify the starting and ending address of the
IP address pool.