DIR-815/AC Wireless AC1200 Dual Band Router
with 3G/LTE Support and USB Port
User Manual
Configuring via Web-based Interface
Figure 148. The page for adding an IPsec tunnel. The General Settings section.
You can specify the following parameters:
Parameter Description
General Settings
Dynamic IPsec
Move the switch to the right to allow a remote host with any public IP
address to connect to the router via IPsec protocol. Such a setting can
be specified for one tunnel only. Connection requests via this tunnel
can be sent by a remote host only.
Remote host
A remote subnet VPN gateway IP address. The field is available, if the
Dynamic IPsec switch is moved to the left.
Identifier
Select an identification method of a remote host from the drop-down
list:
Address: A remote host is identified by its IP address.
FQDN: A remote host is identified by its domain name.
Local identifier value
Specify the value of the identifier.
Page 183 of 221
To Next Page
Loading...
