DIR-815/AC Wireless AC1200 Dual Band Router
with 3G/LTE Support and USB Port
User Manual
Configuring via Web-based Interface
In order to connect your device to a wireless ISP (WISP), on the Device mode page, from the
Connection method list, select the Wi-Fi value. Then from the Work mode list select the
WISP Repeater value. In this mode you can connect your device to another access point,
configure a WAN connection, set your own settings for the wireless network, configure LAN ports
to connect an STB or VoIP phone, and set your own password for access to the web-based interface
of the device.
Figure 27. Selecting an operation mode. The WISP Repeater mode.
In order to connect your device to a wired router for adding a wireless network to the existing local
network, on the Device mode page, from the Connection method list, select the Wired
connection value. Then from the Work mode list select the Access point value. In this mode
you can change the LAN IP address, set your own settings for the wireless network and set your
own password for access to the web-based interface of the device.
Figure 28. Selecting an operation mode. The Access point mode.
Page 46 of 221
To Next Page
Loading...
