4
• Users with DSL providers - If you are using a PPPoE connection, you will need
your PPPoE user name and password. If you do not have this information, contact
your Internet provider. Do not proceed until you have this information.
• Users with Cable providers - Make sure you unplug the power to your modem.
In some cases, you may need to turn it o for up to 5 minutes.
• Advanced Users - If your Internet Service Provider (ISP) provided you with a
modem/router combo, you will need to set it to “bridge” mode so the DIR-819
router can work properly. Please contact your ISP or refer to the user manual for
your modem/router device.
Before you Start
1
Unplug the power to your DSL or Cable modem.
2
Connect an Ethernet cable from the Internet port of the router to the
Ethernet port on your DSL or Cable modem.
Modem
Connect your Router
INTERNET
POWER POWER PORT WPS
4321
RESET
Ethernet Port
Modem
Ethernet Cable
DIR-819
Internet Port (yellow)
To Next Page
Loading...
