4
• Users with DSL providers - If you are using a PPPoE connection, you will need
your PPPoE user name and password. If you do not have this information, contact
your Internet provider. Do not proceed until you have this information.
• Users with Cable providers - Make sure you unplug the power to your modem.
In some cases, you may need to turn it o for up to 5 minutes.
• Advanced Users - If your Internet Service Provider (ISP) provided you with a
modem/router combo, you will need to set it to “bridge” mode so the DIR-822
router can work properly. Please contact your ISP or refer to the user manual for
your modem/router device.
Before you Start
1
Unplug the power to your DSL or Cable modem.
2
Connect an Ethernet cable from the Internet port of the router to the
Ethernet port on your DSL or Cable modem.
Modem
Connect your Router
4 3 2 1 INTERNET
POWER
POWER PORT
WPS
Ethernet Port
Modem
Ethernet Cable
DIR-822
Internet Port (yellow)
To Next Page
Loading...
