D-Link DIR-830M - Configuring WAN Connection; WAN Connection Type Selection

DIR-830M Quick Installation Guide
Conguring WAN Connection
This configuration step is available for the Router and WISP Repeater
modes.
!
You should configure your WAN connection in accordance with data
provided by your Internet service provider (ISP). Make sure that you
have obtained all necessary information prior to configuring your
connection. Otherwise contact your ISP.
1. On the Internet connection type page, click the SCAN button
(available for the Router mode only) to automatically specify the
connection type used by your ISP or manually select the needed value
from the Connection type list.
Static IPv4: Fill in the following fields: IP address, Subnet mask,
Gateway IP address, and DNS IP address.
Static IPv6: Fill in the following fields: IP address, Prefix, Gateway IP
address, and DNS IP address.
32