DIR-878 Quick Installation Guide
Selecting Operation Mode
Select the needed operation mode and click the NEXT button.
Router
In order to connect your device to a wired ISP, on the Device mode page,
from the Connection method list, select the Autonomous value. Then
from the Work mode list, select the Router value. In this mode you can
configure a WAN connection, set your own settings for the wireless network
in the 2.4GHz and 5GHz bands, configure LAN ports to connect an STB or
VoIP phone, and set your own password for access to the web-based interface
of the device.
In order to connect your device to a wireless ISP (WISP), on the Device
mode page, from the Connection method list, select the Autonomous
value. Then from the Work mode list, select the WISP Repeater value. In
this mode you can connect your device to another access point, configure a
WAN connection, set your own settings for the wireless network in the
2.4GHz and 5GHz bands, and set your own password for access to the web-
based interface of the device.
23
To Next Page
Loading...
