DIR-X1530 AX1500 Wi-Fi 6 Gigabit Router
User Manual
Configuring via Web-based Interface
Parameter Description
• LAN: The rule will be applied to the packets transmitted to
the local network.
• GRE: The rule will be applied to the packets transmitted to
the GRE tunnel (available if a GRE tunnel has been created
on the device).
• IPIP: The rule will be applied to the packets transmitted to
the IPIP tunnel (available if an IPIP tunnel has been created
on the device).
• IPsec: The rule will be applied to the packets transmitted to
the IPsec tunnel (available if an IPsec tunnel has been
created on the device).
• PPTP Server: The rule will be applied to the packets
transmitted to the PPTP server (available if a PPTP server
has been created on the device).
• L2TP Server: The rule will be applied to the packets
transmitted to the L2TP server (available if an L2TP server
has been created on the device).
From the Source interface and Destination interface drop-
down lists, select source and destination interfaces for which the rule
will be applied. Leave the Auto values to apply the rule to all
created WAN interfaces.
Source IP address
Set as
Select the needed value from the drop-down list.
Start IPv4 address /
Start IPv6 address
The source host start IPv4 or IPv6 address.
If it is necessary to specify a single address, leave the End IPv4
address / End IPv6 address field blank.
You can choose a device connected to the router's LAN at the
moment. To do this, select the relevant IPv4 or IPv6 address from the
drop-down list (the field will be filled in automatically).
End IPv4 address /
End IPv6 address
The source host end IPv4 or IPv6 address.
Subnet IPv4 address /
Subnet IPv6 address
The source subnet IPv4 or IPv6 address. The field is displayed when
the Subnet value is selected from the Set as drop-down list.
Destination IP address
Set as
Select the needed value from the drop-down list.
Page 204 of 254
To Next Page
Loading...
